Mac Filter; The More Ap Screen - ZyXEL Communications AMG1302-T10A User Manual

Chapter 8 Wireless LAN

8.2.6 MAC Filter

Use this screen to change your Device's MAC filter settings. Click the Edit button in the AP screen.
The screen appears as shown.
Figure 52 Network > Wireless LAN > AP: MAC Address Filter
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN > AP: MAC Address Filter
LABEL
Enable MAC
Filter
Filter Action
Set
MAC Address
Back
Apply
Reset

8.3 The More AP Screen

This screen allows you to enable and configure multiple Basic Service Sets (BSSs) on the Device.
106
DESCRIPTION
Select the check box to enable MAC address filtering.
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Deny to block access to the Device. MAC addresses not listed will be allowed to access
the Device
Select Allow to permit access to the Device. MAC addresses not listed will be denied access
to the Device.
This is the index number of the MAC address.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302-T10A User's Guide