The Reset Button; Using The Reset Button - ZyXEL Communications AMG1302-T10A User Manual

1.7 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to "1234".

1.7.1 Using the Reset Button

Make sure the POWER LED is on (blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
AMG1302-T10A User's Guide
Chapter 1 Introduction
19