Chapter 8 Wireless LAN
Table 28 Network > Wireless LAN > AP
LABEL
Cancel
Advanced Setup
8.2.1 No Security
In the Network > Wireless LAN > AP screen, select No Security from the Security Mode list to
allow wireless devices to communicate with the Device without any data encryption or
authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 47 Network > Wireless LAN > AP: No Security
The following table describes the labels in this screen.
Table 29 Network > Wireless LAN > AP: No Security
LABEL
Security Mode
8.2.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network > Wireless LAN to display
the AP screen. Select Static WEP from the Security Mode list.
100
DESCRIPTION
Click this to restore your previously saved settings.
Click this to display the Wireless Advanced Setup screen and edit more details of your
WLAN setup. See
Section 8.2.5 on page 104
DESCRIPTION
Choose No Security from the drop-down list box.
for more details.
AMG1302-T10A User's Guide