Vlan Settings - HIKVISION DS-3WF03C User Manual

DS-3WF03C User Manual

Set burst less than 1/10 of rate limit, the rate curve is stable totally

Set burst larger than rate limit, the rate curve will hold a while at a higher value then
down to stable
Below is the table that reflects the relationship between egress rate limit and burst.
Egress
RateLimit(kbps)
20000
20000
20000
20000
20000
20000

VLAN Settings

7.5
The VLAN function allows user to create multiple virtual local area network. As show below, we
add a VLAN on port wlan0. The VLAN ID is 10. The range of VLAN ID is 2~4094. Each VLAN
ID represents a different VLAN.
Bridge function is needed to use together with VLAN. As show below, we add VLAN 10 on port
eth0 and wlan0, they are eth0.10 and wlan0.10, and put them into the same bridge. The packets
from eth0.10 or wlan0.10 will be added a VLAN label which ID is 10. That requires: the opposite
wireless connection side must support VLAN 10, the device which connects with eth0 is also need
to support VLAN 10.
Below is a common usage:
Burst(kbyte) （Mbps） Description
0 18.853 Stable
20 19.021 Stable
200 19.205 Stable
2000 19.437 From 23.5 down to stable
20000
80000
Page 29
Throughput when reach stable
Hold on 20 seconds at 24.5, then
19.2
suddenly down to stable
Hold on several minutes at 24.5,
19.2
then suddenly down to stable