HIKVISION DS-3WF03C User Manual page 38

DS-3WF03C User Manual
After the above connection is done, configure the DS-3WF03C device using the
web based configuration menu.
1. In wireless page, set the device to route mode, disable the fireware. If the
internet provided by the ISP (DS-3WF03C connected to) has a DHCP server,
user can set DS-3WF03C's WAN mode to DHCP (Dynamic IP) so that it can
obtain the IP address automatically.
If the internet provided by the ISP(DS-3WF03C connected to) doesn't have a
DHCP server, user need to manually configure all the parameters given by the
ISP, such as the WAN IP, WAN submask, LAN IP, LAN submask, Default
gateway, Primary DNS, Secondary DNS.
Note: LAN IP address and WAN IP address can not be in the same IP segment.
For example, if LAN IP is 192.168.1.*, then WAN IP must be set to 192.168.2.* or
192.168.3.*.
2. In wireless page, set wireless mode to Access Point, set SSID to a random name,
and set output power to a value needed(Max output power is recommended
in the outdoor long distance environment). Then the user needs to choose a
wireless channel and an encryption method.
3. Enable DHCPD at the Tools page. Please refer to chapter 10 for DHCPD setting.
4. When the above settings are done, use a computer to connect to DS-3WF03C
device, and then check whether the connection is successfully.
Note: Users can check whether the connection is successfully by ping
DS-3WF03C device's WAN IP address. If the ping is successfully, this
connection is successfully.
Figure 28 Router mode
Page 37