Table of Contents
Advertisement
DS-3WF03C User Manual
transmission. ACK Time-out Auto Adjust can automatically detect the distances of
the DS-3WF03C devices, and adjust the wireless parameters to achieve the best
link quality.
The XTrans settings is shown in the following Figure 15.
Figure 13 Xtrans setting
To use the Xtrans, the user needs to enable Xtrans mode in the AP device, and set
a priority level in the station device. When several stations are connected to one
AP, different stations demand different throughput. If the station demands higher
throughput, its priority level can be set to High, otherwise set to Low. When the
stations demand the same throughput, their priority level can be set to the same
level.
Note: When using Xtrans mode, the Xtrans button need to be enabled at both AP
and station devices in the web-based configuration menu. The devices from other
vendors can not be connected to DS-3WF03C in the Xtrans mode.
5 Status
Status is the first page shown after logging in. It shows the current configuration
and real-time monitoring of the device, seen in the following Figure 16. This page
is divided into 2 parts: Status and Monitor.
Page 20
Advertisement
Table of Contents
