Table of Contents
Advertisement
DS-3WF03C User Manual
Appendix-A Troubleshooting
1. The device can not be started after power on.
1. The Ethernet cable between the DS-3WF03C device and the POE adaptor is
more than 40 meters long.
2. The Ethernet cable quality is not good enough, and it should be Cat 5e or even
Cat 6 cable.
3. The RJ-45 plugs are not well connected.
2. Can not be restored to the factory setting
Please manually push the Reset button for 5S~10S, then the user can log in the
device by typing the default IP address 192.168.1.36.
3. My computer can not be connected to the DS-3WF03C
Access Point.
Please try the following method to solve the problem:
1. Adjust the direction of the DS-3WF03C device.
Please rotate the DS-3WF03C device since the antenna inside the device is
directional.
2. Switch to other wireless channel
Switch to other wireless channel 'cause there are much interferences in this
channel.
3. Turn off the other interference sources
Maybe there are other WiFi devices nearby and cause interferences. Try to turn
off other WiFi devices nearby, or move DS-3WF03C to another clean
environment.
Page 38
Advertisement
Table of Contents
