Network Configuration Examples; Ap And Station Network; Router Mode - HIKVISION DS-3WF03C User Manual

DS-3WF03C User Manual

11 Network Configuration Examples

11.1

AP and Station Network

In the point-to-point working scenario, user can configure one DS-3WF03A device
to AP, and one DS-3WF03C to station mode, shown in Figure 29.
To make the above network work, user need to use computers to configure the 2
devices, and the detail configurations are described in the following:
1. Configure the 2 DS-3WF03C devices to bridge mode, and disable the firewall,
and set different LAN IP for the 2 devices.
2. In wireless menu, configure the 2 devices to AP and station separatetely, set
the same SSID, the same channel bandwidth (20MHz for default), and set the
same encryption and password for both of the devices.
3. After the above setting is done, using one computer to ping the IP address of
the other computer, if they are connected, user can watch the connection
status in the Status page.
11.2

Router Mode

In the Router mode, the DS-3WF03C works as a router and the network
connection is shown in Figure 31. In Figure 31, The POE port of the POE adaptor is
connected to the DS-3WF03C device's POE port, and the LAN port of the POE
adaptor is connected to the internet. Meanwhile, the LAN port of DS-3WF03C
device is connected to one computer, and then user can configure the device.
Figure 27 AP and Station network
Page 36