HIKVISION DS-3WF03C-D User Manual

HIKVISION DS-3WF03C-D User Manual

Outdoor video wireless network bridge

Advertisement

Quick Links

DS-3WF03C-D Outdoor Video Wireless Network
Bridge
User Manual

Advertisement

Table of Contents
loading

Summary of Contents for HIKVISION DS-3WF03C-D

  • Page 1 DS-3WF03C-D Outdoor Video Wireless Network Bridge User Manual...
  • Page 2 SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL RELEVANT LAWS IN YOUR JURISDICTION BEFORE USING THIS PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS THE APPLICABLE LAW. HIKVISION SHALL NOT BE LIABLE IN THE EVENT THAT THIS PRODUCT IS USED WITH ILLEGITIMATE PURPOSES.
  • Page 3 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS. Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
  • Page 4 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points.
  • Page 5: Table Of Contents

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Table of Contents Chapter 1 Product Overview ..................6 13.1 Product Advantages ..................... 6 13.2 Electrical Specifications....................7 13.3 Features ........................9 13.4 Typical Application ....................... 9 13.5 Applications ........................ 10 13.6 Hardware Overview ....................
  • Page 6: Chapter 1 Product Overview

    2. Longer transmission distance, higher throughput The longest transmission distance of DS-3WF03C-D can be as far as 5 km, and the max throughput can be 300Mbps. It can satisfy the needs of most of the applications.
  • Page 7: Electrical Specifications

    5. Outdoor industrial product DS-3WF03C-D device can work at all kinds of outdoor severe environments, including - 30 to 70 degree temperature, 5% to 95% humidity, while maintain good performance.
  • Page 8 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Items Specifications Standard IEEE802.11 a/n(2T2R 300Mbps) Operation frequency 5.15 to 5.25GHz Modulation mode 802.11 a/n: OFDM Antenna Internal, Gain 15dBi,H:40° V:15° The Max E.I.R.P about 21dBm Output power Receive sensitivity -74dBm@65Mbps, -96dBm@6Mbps 11n:13.5/15/27/30/40.5/45/54/60/81/90/108/120/121.5/135/150/162/180/2...
  • Page 9: Features

    Waterproof housing and accessory kit protects 13.4 Typical Application The DS-3WF03C-D usage examples are shown in figure; it can be used as WIFI AP, CPE, or outdoor PTP, PTMP topology. Therefore, DS-3WF03C-D is suitable for various applications like wireless video transmission, and wireless signal coverage.
  • Page 10: Applications

    Outdoor Video Wireless Network Bridge Figure 1-1 Typical Application 13.5 Applications DS-3WF03C-D can be used widely in the following applications: can be used widely in the following applications: Wireless video surveillance (free Wireless video surveillance (free-way, city, police, oil pipeline, forest and etc.) way, city, police, oil pipeline, forest and etc.)
  • Page 11: Led Description

    13.7 LED Description The LEDs of DS-3WF03C-D can be divided to 2 groups. One group of LEDs are Indicators, including the left 3 LEDs of figure, and they are Power, LAN and WAN indicators. The other group of LEDs are Link Quality, including the right 3 LEDs of figure, shown the signal strength.
  • Page 12: Chapter 2 Installation

    In the bridge mode, please connect the device with the POE power adaptor in the following way: 1. Remove the bottom cover from the DS-3WF03C-D device, and you will see there are 2 RJ45 ports marked with “POE” and “LAN2”.
  • Page 13: Restore To The Factory Settings

    User Manual of User Manual of DS-3WF03C-D Outdoor Video Wireless Network Outdoor Video Wireless Network Bridge other devices, or leave it unconnected other devices, or leave it unconnected 5. Mount the DS-3WF03C 3WF03C-D securely to the pole by locking the strap tightly.
  • Page 14: Chapter 3 Quick Configuration

    This chapter describe how to configure the device quickly. Log In To log in the DS-3WF03C-D device, user needs to configure the TCP/IP of your computer first as the following steps: Right click Local Area Connection icon of your computer and click properties, then click Continue, the Local Area Connection Properties dialog box appears as figure.
  • Page 15 Figure 3-2 IP settings 3. In the above figure, IP address should be set to 192.168.1.*, here * can be a number between 1-255 (but not 36) since the DS-3WF03C-D(T/R) default IP address is 192.168.1.35/36. 4. When the above IP setting is done, input the default IP 192.168.1.35 into the address bar of your web browser, and the following log in interface appears as shown in figure.
  • Page 16: Quick Configuration Of The Device

    Figure 3-3 DS-3WF03C-D Log in interface Quick Configuration of the Device The users will see how to configure the DS-3WF03C-D device quickly in this chapter. 1. The first page shown after log in is the Status page, which indicates the working status, current setting, software version and other information of the DS-3WF03C-D device.
  • Page 17 Bridge mode, and the default LAN IP address is 192.168.1.35. If the user wants to configure the device to Router mode, please click Network in the main menu. If several DS-3WF03C-D devices are connected in the Point-to-Point or Point-to- Multi-Point topologies, they must be configured to different IP address to avoid...
  • Page 18 Station mode: The device acts as a WIFI station, and it can be connected to a normal home access point or DS-3WF03C-D access point. Access Point mode: The DS-3WF03C-D device acts as an access point, which allows normal WIFI stations access. For detail settings of wireless mode, please click Wireless in the main menu.
  • Page 19 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Figure 3-7 Wizard Finish...
  • Page 20: Chapter 4 Tdma

    XTrans technology is developed and patented by Hikvision, utilizing a series of advanced technologies such as TDMA, 5M/10M/20M/40MHz bandwidth support, intelligent rate control, Auto ACK Time-out Adjust, having the advantage of long transmission range, high date rate and robust transmission.
  • Page 21: Chapter 5 Status

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Chapter 5 Status Status is the first page shown after logging in. It shows the current configuration and real-time monitoring of the device, seen in the following figure. This page is divided into 2 parts: Status and Monitor.
  • Page 22: Monitor

    (distances) associated with those routes. The route table contains information about the topology of the network immediately around Figure 5-3 Router Table Bridge Table: It lists all the devices that communicate through the DS-3WF03C-D device.
  • Page 23 AP/Station Information: Showing the status information of the associated devices. For example, if the DS-3WF03C-D device is an AP, and the associated device is a Station, and this Station Information shows the related information of the Station device in the figure.
  • Page 24: Chapter 6 Wireless

    AP can communicate with each other like in ad-hoc mode. WDS AP means this device is an AP in WDS mode. WDS Repeater: A DS-3WF03C-D device can be configured to WDS Repeater mode, so that it can connected to another WDS Station or WDS Repeater.
  • Page 25 Country Code: Different countries allows different channels, use can choose the country code to only allow the device works at the channels permitted in the particular country. Channel Width: Channel width selection, and DS-3WF03C-D device supports 5MHz/10MHz/20MHz/40MHz bandwidth. Max TX Rate: Max transmission rate, and it can be used to limit the max transmission rate of a device.
  • Page 26: Chapter 7 Network

    POE port of the DS-3WF03C-D. After the above connection, the DS-3WF03C-D can work as a router. The LAN2 port of DS-3WF03C-D device acts as the LAN port of the router, and LAN port of POE adaptor acts as the WAN port of the router.
  • Page 27 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Figure 7-2 Router mode WAN Mode: WAN mode can be configured to DHCP, PPPoE and Static IP. When set to DHCP, the device can dynamically get the IP address; otherwise, user needs to manually set the IP address, Netmask, Gateway and other information.
  • Page 28: Bridge Mode

    In Bridge mode, there is no WAN port. The LAN port of the POE adaptor, and the LAN2 port of the DS-3WF03C-D device can all be the LAN port, and the user can choose one of them to use as LAN port. Please refer to figure for the connections in Bridge mode, and the IP address/Netmask information setting is the same as Router mode.
  • Page 29: Ip Aliases

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge IP Aliases Add multiple IP to a network interface. Static Routes This feature can be used to set static routing. Traffic Shaping Traffic shaping is used to control the traffic of ingress/egress based on each network port.
  • Page 30: Vlan Settings

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Below is the table that reflects the relationship between ingress rate limit and burst. Ingress Throughput when reach stable Rate Limit(kbps) Burst(Kbytes) Mbps Description 10000 29.587 Unlimited 10000 4.286 Stable 10000 8.037 Oblique up to stable...
  • Page 31 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Figure 7-5 VLAN Bridge function is needed to be used together with VLAN. As show below, we add VLAN 10 on port eth0 and ath0, they are eth0.10 and ath0.10, and put them into the same bridge.
  • Page 32: Chapter 8 Advanced

    User Manual of User Manual of DS-3WF03C-D Outdoor Video Wireless Network Outdoor Video Wireless Network Bridge Figure 7-7 VLAN Scenarios Chapter 8 Chapter 8 Advanced The Advanced page is shown in The Advanced page is shown in figure. Figure 8-1 Advanced...
  • Page 33 LED configure: This is to configure the signal strength value needed to light on. There are 3 LEDs on DS-3WF03C-D devices (LED3 value > LED2 value > LED1 value). The default values are -86dBm, -71dBm and -56dBm. When LED1 value < signal strength < LED2 value, LED1 is lighted on;...
  • Page 34: Chapter 9 System

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Chapter 9 System System page is shown in figure, and it is divided into the following 4 parts: Configuration, Firmware, Device Setting, Accounts. Figure 9-1 System Page Backup configuration: When clicking Download button, the current configuration can be backed up to a file.
  • Page 35 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Interface Language: Language setting. Accounts: The user can modify the name and password of user and Read-Only Account.
  • Page 36: Chapter 10 Tools

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Chapter 10 Tools The Tools page is shown in figure.
  • Page 37 Figure 10-1 Tools Ping IP: User can input the destination IP address of another device, and click Ping button. If that destination device is successfully connected to the DS-3WF03C-D device, the result shows Alive, otherwise shows Not Alive. Time To Restart: Timing restart equipment.
  • Page 38 When Syslog is enabled, and the System Log server’s IP is also set here, the log information will be output to the Syslog server automatically. NTP/SNMP: If this NTP server is set, and the DS-3WF03C-D device can access to this NTP server. DS-3WF03C-D device automatically calibrate the time and date information with the NTP server and show the time information in the Status page.
  • Page 39 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge IPERF: Test equipment throughput. Device 1 select the "server” and the IPERF interval is the time to display the throughput of the web page. Device 2 select "client" and the IPERF server to fill in the IP address of the device 1. The number of IPERF threads for testing the number of threads running at the same time, it is recommended to set up 10.
  • Page 40: Chapter 11 Ac Management

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Chapter 11 AC Management AC Management page is shown in figure. After this function is enabled, the AC management system must be use d. Figure 11-1 AC Management WTP Name: It’s the name of the device that is displayed on the AC.
  • Page 41: Chapter 12 Logout

    User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge Chapter 12 Logout When you click logout button, the web will quit and return to the login web.
  • Page 42: Chapter 13 Network Configuration Examples

    User Manual of User Manual of DS-3WF03C-D Outdoor Video Wireless Network Outdoor Video Wireless Network Bridge Chapter 13 Chapter 13 Network Network Configuration Configuration Examples Examples 13.1 AP and Station Network AP and Station Network In the point-to-point working scenario, user can configure one...
  • Page 43: Chapter 14 Appendix-A Troubleshooting

    Troubleshooting 1. The device cannot be started after power on. 1) The Ethernet cable between the DS-3WF03C-D device and the POE adaptor is more than 40 meters long. 2) The Ethernet cable quality is not good enough, and it should be Cat 5e or even Cat 6 cable.
  • Page 44 User Manual of DS-3WF03C-D Outdoor Video Wireless Network Bridge 1) The DS-3WF03C-D AP and Station devices are not Line-of-Sight, or there are blocks like a building in between the AP and Station devices. 2) The Station device and AP device is not aligned very well, including both horizontally and vertically, since the antenna of the DS-3WF03C-D is directional.

Table of Contents