LG PRCKD42E Owner's Manual page 51

2
3) CO Sensor (Default Concentration Level) Settings
2
- When the CO sensor is not used, do not check the checkbox
Check the checkbox
- You'll be able to see the CO
enabled by checking the checkbox
- The Default Concentration Level of the CO
used. Set the default CO
- The initial value of the default concentration level is set to 1,000ppm, and the level can be
set between 0~1,500ppm at an increment/decrement of 100ppm.
- If a value exceeding the default concentration level is entered, a message saying "Exceeded
Maximum Input Range", so re-enter the value within the designated range when you get
this message.
! CAUTION
• When the CO sensor is not set
2
- If the CO sensor is neither enabled nor disabled after it's installed, the Auto Ventilate
2
mode among other optional modes cannot be set. So make sure to enable or disable the
CO sensor after installation.
2
2
only when the CO sensor is used.
When the CO
When the CO
2
sensor value in the System View only when the CO
.
sensor must be set before the sensor can be
2
concentration level as shown below.
2
① To set the default concentration level, click the De-
fault Concentration Level display to open a screen
where the default concentration level can be entered.
② Enter the desired input value by using the key button.
③ Enter the default concentration level value and then
click the 'OK' button to enter the input value.
HMI SETTINGS/INSTALLATION
.
sensor is not used.
2
sensor is used.
2
51
sensor is
2