SYSTEM SETTINGS
74
4) Check Valve Operation (DC Type)
Here, you can check the installation and wiring status of each valve and heater for freeze pro-
tection.
① Click the box to open a screen where
the setting can be set/entered.
- The default valve value is set to 0V, and the designated range of angle is between 0 and
10V. A warning message will appear if a value is outside the range of fan settings, in which
case you can re-enter the value within the range.
- Miswiring can cause the valve to malfunction.
Make sure to check the connection status if the valve doesn't work after the 'Apply' button
is clicked.
④ Click the 'Apply' button after
setting the input value to
apply the value in the load.
② Enter the desired input value by using
the key button.
③ Enter the value and then click the
'OK' button to enter the input value.