Decalcification; S Control - Alto-Shaam ML Series Installation Operation & Maintenance

C O M B I T H E R M
It is VERY important to decalcify the oven, particularly in areas
with extremely hard water.
PERFORM ONCE A MONTH
in addition to the daily steam generator flush.
1.
Begin decalcification with the power switch in the OFF position.
2.
Rotate the Steam Generator Drain Cap
approximately 20 to 60 seconds, a sufficient quantity of water will have drained from the steam generator so
that the drain cap can be completely removed.
3.
As the water continues to flow from the
generator, it will have a milky or cloudy
appearance, which indicates deposits in
the generator system are beginning to
flush out. Let the water continue to
drain until the flow completely
subsides. Replace the Steam Generator
Drain Cap by turning it clockwise
until there is a slight resistance.
4.
Unscrew the cap from the
Decalcification Port
use of a funnel, pour one-half gallon
(c. 2 liters) of distilled white vinegar
into the Decalcification Port.
5.
Replace the cap on the Decalcification Port
S c a l d i n g w a t e r w i l l e r u p t f r o m t h e D e c a l c i f i c a t i o n
P o r t
i s r e p l a c e d a n d t i g h t e n e d .
. 2 6
P G
WITH THE OVEN AT ROOM TEMPERATURE
until water begins to flow from the four holes in the cap. In
. With the
w h e n t h e o v e n i s o p e r a t i n g u n l e s s t h e c a p
# 6 0 0 1
C O M B I T H E R M E L E C T R I C I N S TA L L AT I O N A N D M A I N T E N A N C E M A N UA L
D E C A L C I F I C AT I O N
®
and tighten securely.
C O N T R O L
O P T I O N