Show Ip Dhcp Snooping; Show Ip Dhcp Snooping Binding; Switch Cluster Commands; Table 4-79 Switch Cluster Commands - SMC Networks SMC8126L2 Management Manual

show ip dhcp snooping

This command shows the DHCP snooping configuration settings.
Command Mode
Privileged Exec
Example
Console#show ip dhcp snooping
Global DHCP Snooping status: disable
DHCP Snooping is configured on the following VLANs:
1
Verify Source Mac-Address: enable
Interface
----------
Eth 1/1
Eth 1/2
Eth 1/3
Eth 1/4
Eth 1/5

show ip dhcp snooping binding

This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
Console#show ip dhcp snooping binding
MacAddress
----------------- --------------- ---------- ------------------- ---------
11-22-33-44-55-66 192.168.0.99
Console#

Switch Cluster Commands

Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. A switch cluster has a "Commander" unit that is
used to manage all other "Member" switches in the cluster. The management station
uses Telnet to communicate directly with the Commander throught its IP address,
and the Commander manages Member switches using cluster "internal" IP
addresses. There can be up to 16 Member switches in one cluster. Cluster switches
are limited to within a single IP subnet.
Command
cluster
cluster commander
Trusted
----------
No
No
No
No
Yes
IpAddress Lease(sec) Type

Table 4-79 Switch Cluster Commands

Function
Configures clustering on the switch
Configures the switch as a cluster Commander
Switch Cluster Commands
0 Static
4
VLAN Interface
1 Eth 1/5
Mode Page
GC 4-238
GC 4-239
4-237