NETGEAR ME103 User Manual page 15

Wireless Access Point User Guide
Data - IP Settings Screen
DHCP Client
Enable/Disable If set to Enable, the Wireless Access Point will obtain an IP address
from your DHCP Server. This is the default.
If set to Disable, you need to enter the IP Address, IP Subnet Mask,
Gateway, and DNS, as explained below.
This setting should be changed to Disable if your LAN does not have a
DHCP Server.
IP Address Only required if DHCP Client is set to Disable.
Enter an unused IP Address from within the range used by your LAN.
IP Subnet Mask Only required if DHCP Client is set to Disable.
Enter the Subnet Mask for the LAN segment to which the Wireless
Access Point is attached (the same value as the PCs on that LAN
segment).
Gateway Only required if DHCP Client is set to Disable.
Enter the Gateway for the LAN segment to which the Wireless Access
Point is attached (the same value as the PCs on that LAN segment).
Only required if DHCP Client is set to Disable.
DNS
Enter the DNS (Domain Name Server) used by PCs on your LAN.
MAC Address
MAC Address The MAC address (physical address) of the Wireless Access Point is
displayed here. This is for information only; the MAC address cannot
be changed.
Figure 8: IP Settings Screen
12