NETGEAR ME103 User Manual page 11

Wireless Access Point User Guide
1. Attach the wireless antennae to the connectors provided on the back of the router. Secure
each antenna by turning the grooved or ridged ring on the antenna until snug (Do not over
tighten).
2. Use a standard LAN cable to connect the "Ethernet" port on the Wireless Access Point to
a 10/100BaseT hub on your LAN.
3. Connect the supplied power adapter to the Wireless Access Point and a convenient power
outlet.
4. Check the LEDs:
•
The Status LED should flash, then turn OFF.
•
The Power, WLAN, and Link/Act (LAN) LEDs should be ON.
For more information, refer to Front Panel LEDs in Chapter 1.
8