NETGEAR ME103 User Manual page 13

Wireless Access Point User Guide
If there is no reply ("Request timed out")
•
Check that the Wireless Access Point is properly installed, LAN connection is
OK, and it is powered ON.
•
Ensure that your PC and the Wireless Access Point are on the same network
segment. (If you don't have a router, this must be the case.)
4. Start your Web browser.
5. In the Address box, enter "HTTP://" and the IP Address of the Wireless Access Point
e.g.
HTTP://192.168.0.5
6. You should then see a login prompt, which will ask for a User Name and Password.
7. Enter admin for the user name, and password for the password.
These are the default values. The password (but not the user name) can and should be
changed. Always enter the current password, as set on the Change Password screen.
8. You will then see the Information screen, which displays the current settings and status.
No data input is possible on this screen.
9. From the menu, select and configure the following screens, as described in the following
sections:
•
IP Settings
•
Wireless Settings
•
Wireless Mode
•
Security Settings
•
Change Password
10. Setup of the Wireless Access Point is now complete.
Wireless stations must now be set to match the Wireless Access Point. See Chapter 4 for
details.
Figure 5: Ping Command
Figure 6: Password Dialog
10