Emu 7 - Removal And Installation - MTU 16V4000M*3 series Operating Instructions Manual

8.24.6 EMU 7 – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
☑ Engine electronics is powered off.
NOTICE
Wrong engine governor installed.
Engine damage!
• When reassembling an engine, make sure that the governor with the data record for the given engine
is installed.
Removing ECU with EMU from
engine
1. Note or mark assignment of cables and
plugs.
2. Remove all screws (2).
3. Undo clips (3) on connectors.
4. Remove all male connectors.
5. Remove screws (1).
6. Remove ECU (5) with EMU (4).
Removing EMU
1. Unscrew screws on base of EMU (4).
2. Remove EMU (4) from ECU (5).
Installing EMU
1. Place EMU (4) on ECU (5).
2. Screw in and tighten screws on base of EMU (4).
Installing ECU with EMU on engine
1. Install in reverse order. Ensure correct assignment of plugs and sockets.
2. Check resilient mount before installing.
Result: If resilient mount is porous or defective then replace it.
MS15035/00E 2018-08 | Accessories for (Electronic) Engine Governor / Control System | 263