Supplementary Fuel Filter - Replacement - MTU 16V4000M*3 series Operating Instructions Manual

8.9.2 Supplementary fuel filter – Replacement
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Filter wrench
Diesel fuel
Easy-change filter
Synthetic ring
DANGER
Components are moving or rotating.
Risk of crushing, danger of parts of the body being caught or pulled in!
• Operate the engine at low load only. Keep clear of the danger zone of the engine.
WARNING
Fuels are combustible and explosive.
Risk of fire and explosion!
• Avoid open flames, electrical sparks and ignition sources.
• Do not smoke.
• Wear protective clothing, protective gloves, and safety glasses / facial protection.
WARNING
High level of engine noise when the engine is running.
Risk of damage to hearing!
• Wear ear protectors.
NOTICE
Damage to component!
Severe material damage!
• For filter replacement with the engine running, operate the engine at low engine load.
• The filter which is to be replaced must be cut out for a brief period only.
Replacing fuel filter with the en-
gine stopped
1. Cut out the filter to be replaced (2) using
three-way cock (3):
B Left-hand filter switched off
C Right-hand filter switched off
2. Remove the cut-out oil filter (2) using an oil
filter wrench.
3. Clean sealing surface on filter head.
4. Check sealing ring of new filter (2) and coat
with fuel.
5. Screw on filter (2) and tighten manually.
6. Turn three-way cock (3) into position (A)
where both filters are operational.
7. Replace other fuel filters in the same way.
8. Open vent screws (1) to vent fuel system.
Part No.
F30379104
(→ Spare Parts Catalog)
(→ Spare Parts Catalog)
MS15035/00E 2018-08 | Fuel Filter | 185
Qty.
1