MTU 16V4000M*3 series Operating Instructions Manual page 181

8. Press in injector with installation/removal jig.
9. Remove installation/removal jig.
10. Coat screw mating face (2) and thread with
engine oil.
11. Fit hold-down clamp (1) in correct position, fit
screw (2) and tighten by hand.
Note: Make sure parts are perfectly clean.
12. Apply engine oil to thread, sealing taper and
thrust ring of adapter (3).
13. Coat O-ring on adapter (3) with assembly
compound (Kluthe Hakuform 30-15).
14. Install adapter (3).
15. Use torque wrench to tighten screw (2) to specified tightening torque.
Name
Screw
16. Use torque wrench to tighten adapter (3) to specified tightening torque.
Name
Adapter
Note: Make sure parts are perfectly clean.
17. Coat thread and sealing cone of HP line (5) with engine oil.
18. Coat O-rings with assembly compound (Kluthe Hakuform 30-15).
19. Thread in HP line (5), ensuring that the sealing areas are not damage.
Size Type
M12 Tightening torque
Size Type
Tightening torque
MS15035/00E 2018-08 | Injection Valve / Injector | 179
Lubricant Value/Standard
(Engine oil) 100 Nm+10 Nm
Lubricant Value/Standard
(Engine oil) 100 Nm+10 Nm