Pitney Bowes DM Series Installation And Operator's Manual page 5

Installation Step 1: Physically connect your system to the network socket
DM220i series
Plug into USB port on
Mailing System
USB cable supplied
with network
adapter
1. Turn off power to the System.
2. Plug the Ethernet cable into your router or network wall
socket.
3. Attach the Network Adapter to the Ethernet cable and
then plug the Network Adapter into one of the USB
Ports on the Mailing System using the short USB cable
that comes with the Adapter.
NOTE: On the DM500-DM1000, preferably use the port
on the rear of the IntelliLink® Control Centre if this is
not already in use.
SDC876B Constant Connection (LAN Connection) Guide
DM300c and DM400c series
IntelliLink® Control Centre
Ethernet cable
Network Adapter
4. Turn the System power back on.
5. Once the System starts and displays the Mail Run/
Home screen, the LED's on the Network Adapter
should light up or flicker within 15 seconds. This
indicates there is a connection to the Network.
DM500 to DM1000
Connect to your
router or network
wall socket
EN
DM475/DM450+ only
Plug directly
into system
LAN port
Connect to your
router or network
wall socket
1. Turn off power to the System.
2. Plug the Ethernet cable into your
router or network wall socket.
3. Plug the other end of the cable
into the LAN port on the rear of
the system.
4. Turn the System power back on.
<< Return to Contents