© Panduit Corp. 2018
Cut off excess cable tie carrier strip as shown. It is important to cut along the edge of the leading side of a
locator pad. Dotted lines represent potential cut locations.
Fig. 15
Leading Edge
2. Pull the end of the cable tie strip and guide the cable tie carrier strip against the back edge of the ramp as the
cable ties enter the cover opening. Slide the carrier strip into the opening until it stops.
PA27647A01_05
OPERATION MANUAL
ENGLISH
Fig. 14
Page: 18 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
Locator Pads
12-2018