Panduit PAT1M4.0 Operation Manual page 29

© Panduit Corp. 2018
The Pulse represents the sensor events that have been triggered successfully during the last cycle.
The Level represents the status of the sensors at any given time. Reset clears all triggered events of
the last cycle. Pressing the "Back" icon after reviewing this display will return to the previous menu
level.
e) Pressing the "Settings" icon will provide access to the following functions displayed:
i.
ii.
iii.
PA27647A01_05
OPERATION MANUAL
ENGLISH
MAINTENANCE > SENSORS
STATE
1) TRIGGER
2) EXIT
3) TOOL
4) DETENT
5) JAW
6) DISPENSER
7) ALIGN
8) COVER
MAINTENANCE > SETTINGS
COLLECTOR
AIR BURST
ALARM
The AUTO OFF / AUTO ON feature enables the PAT 4.0 to start new cycles by
continuing to hold down the trigger at the end of a cycle. There are three (3) AUTO
modes:
1. AUTO OFF
2. AUTO1 (Fastest)
3. AUTO2 (Fast)
When you power off the PAT4.0, the AUTO mode will revert back to "AUTO OFF";
and you will need to turn the AUTO mode back on after a power cycle.
Pressing the "Air Burst" icon provides a burst of air to dislodge and advance the cable
tie to the jaw area of the tool. The "Air Burst" button can be pressed again if the cable
tie does not advance to the jaw area. NOTE: Care should be taken to not activate the
air burst when the hose and or tool is not attached to avoid injury. Pressing the "Back"
will return to the previous menu level.
Pressing the "ByPass" icon allows the user to use the trigger to clear the tie in tool error
without using the service panel. When the "ByPass" is enabled a green check will
appear next to the icon. When the "ByPass" is disabled a red check will appear next to
the icon. Pressing the "Back" will return to the previous menu level.
Page: 27 of 64
PULSE LOCATION






RESET
AUTO OFF
BYPASS CHOPPER
LANGUAGES UNLOAD
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
19


BACK
24
CONVEY
BACK
12-2018