Panduit PAT1M4.0 Operation Manual page 35

© Panduit Corp. 2018
POSSIBLE CAUSE: This occurs if the dispenser rotary receiver is prevented from advancing (rotating) to the next
position. This may be caused by a jam due to bowed or misaligned cable ties feeding into the rotary receiver, or a
jam due to a backed-up cable tie carrier strip in the carrier strip exit chute.
CORRECTIVE ACTION: Press the "Silence" icon to turn the alarm signal "off". Check the rotary receiver
alignment by pressing Maintenance > Sensors to verify that both the "Dispenser" and "Align" states are "green". If
the states are "red", check the following areas for issues that may have caused the Dispenser Jam
NOTE: Protective eyewear must be used at all times.
1. Check and clear the scrap chute of all carrier strip debris. Using a light, look down the chute and verify
that the chopper blade is up. If the blade is down, press Maintenance> Settings and press Chopper icon
twice.
2. Disconnect the hose from the front of the dispenser and check the dispenser launch tube for loose cable
ties. Open the cover to the dispenser, use a flash light above the rotary receiver to illuminate the launch
tube. Verify that there are no cable ties stuck in the tube. If there are cable ties stuck in the launch tube,
send the dispenser to maintenance for repair.
3. Check the loading area of the rotary receiver for any obstructions or pinched cable ties. Clear the parts
that are interfering.
4. If there are no obstructions in these areas, go to Settings > Maintenance and press the "Unload" icon four
times. Gently pull on the remaining carrier strip to remove the reel going into the dispenser. Continue to
press the "Unload" button until all cable ties have fallen out the bottom of the dispenser. If the jam persists
when trying to remove the cable ties, remove the rear motor cover and use the wrench flats on the
extended shaft to help remove the ties.
Cut the excess carrier strip and any distorted or damaged cable ties from the cable tie strip. Perform the normal
loading procedure.
Press the "Unload" icon to reverse cable ties out until the jam and all remaining loose cable ties and the carrier
strip are cleared from the rotary receiver. Cut the excess carrier strip and any distorted or damaged cable ties from
the cable tie strip. Perform the normal loading procedure.
PREVENTION: To prevent this problem from recurring, load the dispenser with care to prevent misaligned cable
ties in the rotary receiver, and empty the carrier strip scrap bin every 1/2 reel of cable ties.
PA27647A01_05
OPERATION MANUAL
ENGLISH
MAINTENANCE > SETTINGS
COLLECTOR
AIR BURST BYPASS
ALARM LANGUAGE
Page: 33 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
26
CUTTER CONVEY
UNLOAD BACK
12-2018