Panduit PAT1M4.0 Operation Manual page 43

© Panduit Corp. 2018
POSSIBLE CAUSE: This will happen when the exit of the dispenser is blocked so that the cable tie cannot exit the
dispenser. It may be blocked by a cable tie that was not removed from an earlier error, or from excess debris (dirt,
grime, etc.) on the dispenser exit sensor lens. The cable tie has not exited the dispenser and must be removed
before actuating the tool.
CORRECTIVE ACTION: Press the "Silence" icon to turn the alarm signal "off". Disconnect feeder hose from
dispenser. Look for cable tie in dispenser connector block and remove cable tie, if present. Reconnect feeder
hose, and resume operation. If cable tie is not found, reconnect feeder hose. Straighten the feeder hose to
eliminate any bends or twists and point the tool away from yourself and others. Press the "Air burst" icon to
provide a burst of air to dislodge and advance the cable tie to the jaw area of the tool. The "Air Burst" icon can be
pressed again if the cable tie does not advance to the jaw area. When the cable tie is advanced to the tool jaw
PA27647A01_05
OPERATION MANUAL
ENGLISH
ERROR > HELP
DETACH HOSE, REMOVE OBSTRUCTION
PREVIOUS
MAINTENANCE
Help Screen Step 1
ERROR > HELP
RE-ATTACH HOSE TO DISPENSER
AIR BURST LOAD
PREVIOUS
MAINTENANCE
Help Screen Step 2
ERROR > HELP
PRESS AIR BURST, REMOVE TIE
AIR BURST LOAD
PREVIOUS
MAINTENANCE
Help Screen Step 3
Page: 41 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
66
NEXT BACK
67
NEXT BACK
68
BACK
12-2018