Panduit PAT1M4.0 Operation Manual page 37

© Panduit Corp. 2018
POSSIBLE CAUSE: This occurs if a cable tie is caught or remains in the feeder hose upon actuation. This may
be caused by a severe bend or twist in the feeder hose, low air pressure, or an interrupted cycle. When this occurs,
the tool cannot be cycled until the cable tie is cleared from the hose.
CORRECTIVE ACTION: At the error screen press the "Silence" icon to turn the alarm signal "off". If the "Help"
icon is pressed steps 1 thru 3 will illustrate the following to clear the cable tie from the feeder hose, straighten the
hose to eliminate any bends or twists and point the tool away from yourself and others. Press the "Air burst" icon
to provide a burst of air to dislodge and advance the cable tie to the jaw area of the tool. The "Air Burst" icon can
be pressed again if the cable tie does not advance to the jaw area. When the cable tie is advanced to the tool jaw
area, the "Tie in tool" message will appear and the buzzer will sound. Press the "Silence" icon to turn the alarm
signal "off". Remove the cable tie from the jaw area and then press the "Back" icon. Press the "Load" icon to load
one cable tie into the dispenser and continue operation. If the cable tie does not advance to the tool jaw area after
depressing the "Air Burst" icon several times, replace the feeder hose with another and notify your maintenance
department. Pressing the "Back" will return to the previous menu level.
PREVENTION: To prevent this problem from recurring, always prevent any severe bends or twists in the feeder
hose, and verify that the air pressure is between 65 and 85 PSIG (4,5 and 5,8 bar), with a maximum 10 PSI (0,7
bar) drop.
PA27647A01_05
OPERATION MANUAL
ENGLISH
ERROR > HELP
CHECK HOSE FOR BENDS
PREVIOUS
MAINTENANCE
Help Screen Step 1
ERROR > HELP
STRAIGHTEN, PRESS AIR BURST
AIR BURST LOAD
PREVIOUS
MAINTENANCE
Help Screen Step 2
Page: 35 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
46
NEXT BACK
47
NEXT BACK
12-2018