Panduit PAT1M4.0 Operation Manual page 54

© Panduit Corp. 2018
INTERVAL MAINTENANCE PROCEDURE (See Figure 8 below)
Clean tool housings and gears of debris (not shown).
(Maintenance department must perform this procedure.)
1. Lubricate detent cam follower.
(Maintenance department must perform this procedure.)
Every
2. Clean and lubricate all pivots and shafts.
100,000
(Maintenance department must perform this procedure.)
cycles
3. Oil shaft (1 drop) on each side of Gripper Drive Gear.
(Maintenance department must perform this procedure.)
4. Clean and re-grease the Cam on the Front Jaw Gear.
(Maintenance department must perform this procedure.)
Every
200,000
Replace PHM Hose (not shown).
cycles
4. Replace the left hand housing in position and fasten the left hand housing to the tool using the 5 socket
head cap screws removed in Step 2 (see Fig. 20). Use a 2.5 mm hex wrench to torque the cap screws to
60 oz - in (0,42 Nm).
5. Replace tip collector and attach PHM Feeder Hose as required to resume operation.
The following maintenance procedures may be required every 500,000 cycles or more. Contact your maintenance
department as required to perform the following procedures at the prescribed intervals.
INTERVAL
Every 500 000 cycles
(=100 cable tie reels)
Every 750,000 cycles
(=150 cable tie reels)
Every 1,000,000
cycles
(=200 cable tie reels)
PA27647A01_05
OPERATION MANUAL
ENGLISH
UNIT MAINTENANCE PROCEDURE
PAT1M4.0 Clean tool sensor lens.
PAT1.5M4.0 (Maintenance department must perform this procedure.)
Clean dispenser, tie and exit sensor, lens.
PDM4.0
(Refer to Cleaning the Dispenser Exit Sensor Lens section
below.)
PAT1M4.0 Replace tool transfer tube, if worn.
PAT1.5M4.0 (Maintenance department must perform this procedure.)
Clean and re-grease piston and O-rings in connection block.
PDM4.0
(Maintenance department must perform this procedure.)
Page: 52 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
LUBRICANT
N/A
General Purpose
Light Machine Oil
Schaeffer's Moly Ultra 800 EP
N/A
Fig. 21
12-2018