ABR 3000 Series Barcode Reader
8.2.4 ABR Series Manual Installation in Studio 5000 Logix Designer
Software
If the EDS file installation in the previous section is not possible, follow the steps of this section. Otherwise skip this section.
1. Add a generic Ethernet module to the PLC's Ethernet card.
a) Click New Module.
b) Select Generic Ethernet Module.
2. Configure the Module Properties, including the Name and IP Address of your choice, and using the Connection
Parameters and Comm Format shown.
62
Figure 76. Add Ethernet Module
Figure 77. Select Module Type
Figure 78. Module Properties
www.bannerengineering.com - Tel: + 1 888 373 6767