ABR 3000 Series Barcode Reader
3. Under Deactivation, select the same input and set the polarity to Trailing.
When physical Input 1 turns on, the Industrial Ethernet host controller will see the ABR Output Bit 0 turn on.
8.1.6 Transmitting Output Data Messages Using Industrial Ethernet
To send the result output data from the ABR to the Industrial Ethernet host controller, use the following steps:
1. Go to Output Setup.
Should step 1 be Data Formatting rather than Output Setup?
2. Click on the Message you wish to send.
52
Input 1 echo to Industrial
Ethernet Master on
Reader Output Bit 0
Figure 63. Digital Intput Echo to Industrial Ethernet
www.bannerengineering.com - Tel: + 1 888 373 6767