Table of Contents
Advertisement
3. To exit the test, press the Smart Teach button once.
Note: By default, the Test exits automatically after three minutes.
4.2 Focus/Aiming
The reader includes a built-in aiming system to aid in reader positioning. Access the aiming system through the Smart
Teach Interface.
1. Apply power to the reader.
During startup, all of the LEDs blink for one second. On the connector side of the reader near the cable, the Power
LED (blue) indicates the reader is correctly powered.
2. Enter Focus/Aim mode by pressing and holding the Smart Teach button until the
3. Release the button to enter Aim mode.
The aiming system turns on.
4. Place an application-specific code in front of the reader at the reading distance indicated for your model (see
the Focus
on page 9).
5. Position the center of the code 8 mm to the left of the aiming system indicator, as shown in the following figure.
6. Exit Aim mode by pressing the Smart Teach button once. The aiming system turns off.
4.3 Setup
Once entered, the imager automatically performs the Image Acquisition parameter calibration for the specific code
presented to it.
1. Enter Setup mode by pressing and holding the Smart Teach button until the
2. Release the button to enter Setup mode.
The
Setup LED blinks until the procedure is completed. The Setup procedure ends when the Image Acquisition
parameters are successfully saved in the reader memory, the
and exits Setup mode.
3. If the calibration cannot be reached after a timeout of about 5 (five) seconds, ABR exits without saving the
parameters to memory, the
Figure 33. Smart Teach Interface: Aim Mode
Figure 34. Aiming Mode Using the Red Crosshairs
Figure 35. Smart Teach Interface: Setup Mode
Setup LED stops blinking, and the ABR beeps once.
www.bannerengineering.com - Tel: + 1 888 373 6767
ABR 3000 Series Barcode Reader
Focus/Aim LED is on.
FOV
Setup LED is on.
Setup LED stops blinking, the ABR beeps once,
Set
29
Advertisement
Table of Contents
