Reading Phase - Banner ABR 3000 Series Instruction Manual

ABR 3000 Series Barcode Reader
10. Click on the Data Matrix ECC 200 symbology under the Image Settings branch (enabled by default).
If this symbology is among those in your application it will be shown in the image display with its code symbology
name. A small green box around it indicates it is decoded.
Note: The large green box for each symbol indicates the code localization area which by default is
equal to the maximum FOV. Resize and move the box by dragging the borders with the mouse.
The code must be found within this area in order to be decoded.
11. Add application-specific codes to the Code Settings by selecting them from the icons over the Configuration
Parameters tree area.
12. If the Data Matrix symbology is not used, delete it from the Code Settings with the
If you don't know the code type, use the Code Autolearn
Manager Instruction Manual for details.
13. For each code symbology set the relative parameters according to your application.

6.3 Reading Phase

1. Click
2. Select your application-specific Operating Mode from the icons over the Configuration Parameters tree area:
•
Continuous
•
One Shot
•
Phase Mode
Continuous Mode and Acquisition Trigger are shown by default.
3. Configure the relative Operating Mode parameters from the Reading Phase parameters panel.
Different groups appear in the panel depending on the selected icons over the Configuration Parameters tree area.
17
The Code Autolearn procedure will not recognize the following symbologies: Pharmacode, MSI, Standard 2 of 5, Matrix 2 of 5.
38
Figure 46. Decoded Symbology
17
Reading Phase.
www.bannerengineering.com - Tel: + 1 888 373 6767
feature by clicking the icon. See the Barcode
icon.