Usb Device Discovery - Banner ABR 3000 Series Instruction Manual

ABR 3000 Series Barcode Reader
1. Confirm the network connections. Changing the Local Area Connection (LAN) properties of the programming
computer to be compatible with the ABR device on the network may be required for connection.
a) Click the Start button, then on the Start menu, click Control Panel or search for Control Panel.
b) In Control Panel, click Network and Internet, then click Network and Sharing Center, and then click Change
adapter settings.
c) Right-click on the connection that you want to change, then click Properties.
If you are prompted for an administrator password or confirmation, enter the password or provide confirmation.
d) In the connection properties, click Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
e) In the Internet Protocol (TCP/IPv4) Properties, select Use the following IP address.
f) Make sure that the IP address is 192.168.3.1, and the subnet mask is 255.255.255.0.
The IP address must be compatible with the default device address 192.168.3.100.
2. As an alternate method, change the IP address of the device.
a) Add the device to the LAN by aligning its IP Address to the network. The network administrator should provide
valid LAN address(es).
b) Click the
device wrench icon to open the Device Environment Configuration window.
c) Change the Ethernet Settings (IP Address, Subnet Mask, Gateway Address, etc.) according to the network
requirements.
d) Click OK.
3. In Barcode Manager, click
The device displays in Sensor Neighborhood with a dark gray icon, meaning it is now part of the LAN and can be
configured. The new IP address also displays.
4. Double-click or drag the
Details about the device display in this area.
After device discovery, configure your device through Barcode Manager.

5.3 USB Device Discovery

The following configuration procedure assumes that a laptop computer running Barcode Manager is connected to an ABR
3000 USB model reader through the USB port using cable MQDEC-1703SS-USB or CSB-M121701USB02M121702.
ABR 3000 Ethernet models can also connect by USB. However, they do not show up with this device discovery method.
ABR 3000 Ethernet Model Connection via USB available at
For more information see
32
Figure 38. Local Area Connection Properties
Find Devices.
device icon into the Selected Device Information Area.
Figure 39. Device Selection—Selected Device Details
www.bannerengineering.com - Tel: + 1 888 373 6767
www.bannerengineering.com
.