Table of Contents
Advertisement
6 Device Configuration
6.1 Automatic Setup
To begin configuration, the reader must be correctly mounted at the correct reading distance for your application so that its
Field of View covers the application reading area.
Automatic Setup provides an automatic procedure for setting optical/illumination and code definition parameters to obtain
the most stable decoding conditions for a single code symbology based on the images presented to the reader. It can be
set to include Image Filters if necessary. See the table below for codes and filters managed by Automatic Setup.
Enabled 1D Codes
Code 128
EAN 128
Code 39
Code 93
Codabar
PDF417
MICRO PDF417
GS1 DataBar
1. Click
Open Device Configuration. The Open Device Configuration window opens showing the list of
configurations (jobs) currently saved on the device. For new devices, the only saved configuration is the Default
configuration.
2. Click OK. The device enters continuous mode and begins acquiring images.
3. Place the application code in front of the reader at the correct application reading distance.
4. If needed, set the focus manually. See
5. After the code is positioned, click
Note: If the image display area is too dark to see the images being captured, drag the Gain and
Exposure Time sliders to the right to increase visibility. This will not affect Automatic Setup.
6. Click Start Automatic Setup. The Automatic Setup window opens.
GS1 DataBar Stacked
GS1 DataBar Limited
GS1 DataBar Expanded
GS1 DataBar Expanded Stacked
UPCEAN Family EAN13
UPCEAN Family EAN8
UPCEAN Family UPCA
UPCEAN Family UPCE
Set the Focus
Pause to stop image acquisition.
Figure 42. Gain and Exposure Time
Figure 43. Automatic Setup
www.bannerengineering.com - Tel: + 1 888 373 6767
Enabled 2D Codes
Data Matrix ECC 200
QR
Micro QR
Aztec
MAXICODE
DOTCODE
on page 9.
ABR 3000 Series Barcode Reader
Enabled Filters
Erode 3×3, 5×5 and 7×7
Dilate 3×3, 5×5 and 7×7
Smoothing
35
Advertisement
Table of Contents
