Table of Contents
Advertisement
ABR 3000 Series Barcode Reader
4.4 Learn
Once entered, the imager starts a procedure to automatically detect and recognize a single code
Successive Learns will substitute the current code. To configure multiple codes, use the Barcode Manager Auto-learn
procedure.
Exit Learn mode at any time by pressing the Smart Teach button once. After a short delay the Learn procedure is cancelled.
1. Enter Learn mode by pressing and holding the Smart Teach button until the
2. Release the button to enter Learn mode.
The
Learn LED blinks until the procedure is complete. The Learn procedure ends when the Image Processing
and Decoding parameters for a single code are successfully saved in the reader memory, the Green Spot is
activated, the
Learn LED stops blinking, the ABR beeps once, and exits Learn mode.
Note: The PPI (Pixels Per Inch) Setup Chart cannot be used to set the Code 128 symbology (even though
the reader successfully reads the code). Use the application-specific code if you need to set this
symbology.
Note: If you have used this procedure to configure the ABR, go to
13
The Learn procedure does not recognize the following symbologies: Postal Codes, Pharmacode, MSI, Standard 2 of 5, or Matrix 2 of 5. Configure
through Barcode Manager for these codes.
30
Figure 36. Smart Teach Interface: Learn Mode
www.bannerengineering.com - Tel: + 1 888 373 6767
13
which is presented to it.
Learn LED is on.
Test Mode
on page 28.
Advertisement
Table of Contents
