Configuring Pim6 Sparse Mode Parameters - Cisco Nexus 7000 Series Configuration Manual

Configuring PIM and PIM6

Configuring PIM6 Sparse Mode Parameters

Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Command or Action
config t
Example:
switch# config t
switch(config)#
ipv6 pim bsr{listen[forward] |
forward[listen]}
Example:
switch(config)# ip pim auto-rp listen
show ipv6 pim rp
[ipv6-prefix][vrfvrf-name|all]
Example:
switch(config)# show ipv6 pim rp
ipv6 pim bidir-rp-limit limit
Example:
switch(config)# ipv6 pim bidir-rp-limit
4
ipv6 pim register-rate-limit rate
Example:
switch(config)# ipv6 pim
register-rate-limit 1000
ipv6 routing multicast holddown
holddown-period
Example:
switch(config)# ipv6 routing multicast
holddown 100
show running-configuration pim6
Example:
switch(config)# show
running-configuration pim6
interface interface
Example:
switch(config)# interface ethernet 2/1
switch(config-if)#
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring PIM6 Sparse Mode Parameters
Purpose
Enters global configuration mode.
(Optional) Enables listening or forwarding of
BSR messages. The default is disabled, which
means that the software does not listen or
forward BSR messages.
(Optional) Displays PIM6 RP information,
including BSR listen and forward states.
(Optional) Specifies the number of Bidir RPs
that you can configure for IPv6. The maximum
number of Bidir RPs supported per VRF for
PIM and PIM6 combined cannot exceed 8.
Values range from 0 to 8. The default is 2.
(Optional) Configures the rate limit in packets
per second. The range is from 1 to 65,535. The
default is no limit.
(Optional) Configures the initial holddown
period in seconds. The range is from 90 to 210.
Specify 0 to disable the holddown period. The
default is 210.
(Optional) Displays PIM6
running-configuration information, including
the Bidir RP limit and register rate limit.
Enters interface mode on the specified
interface.
85