Cisco Nexus 7000 Series Configuration Manual page 63

Configuring MLD
Step 4
Step 5
Command or Action
Option
ipv6 mld immediate-leave
Example
switch(config-if)# ipv6 mld
immediate-leave
show ipv6 mld interface [interface] [vrf
vrf-name | all] [brief]
Example:
switch(config)# show ipv6 mld interface
copy running-config startup-config
Example:
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring MLD Interface Parameters
Purpose
Description
Note Only the
match ip
multicast
group
command is
supported in
this route map
policy. The
match ip
address
command for
matching an
ACL is not
supported.
Enables the device to
remove the group entry
from the multicast routing
table immediately upon
receiving a leave message
for the group. Use this
command to mnimize the
leave latency of MLDv1
group memberships on a
given MLD interface
because the device does
not send group-specific
queries. The default is
disabled.
Note Use this
command only
when there is
one receiver
behind the
interface for a
given group.
(Optional) Displays MLD information about
the interface.
(Optional) Saves configuration changes.
49