Cisco Nexus 7000 Series Configuration Manual page 190

Nx-os multicast routing
Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

Configuring Multicast Extranet
Procedure
Step 1
Enter configuration mode.
configure terminal
Step 2
Support RPF selection in a different VRF:
ip multicast rpf select vrf src-vrf-name group-list group-range
• vrf src-vrf-name—Specifies the source VRF name. The name can be a maximum of 32 alphanumeric
characters, and is case sensitive.
• group-list group-range—Specifies the group range for the selected RPF. The format is A.B.C.D/LEN
with a maximum length of 32.
To disable the support, use the no form of this command.
Step 3
View the running configuration information for the IPv4 multicast routes:
show ip mroute
Step 4
Save the configuration changes:
copy running-config startup-config
Configuration example for PVLAN over OTV
This example shows how to display information about running configuration for IPv4 multicast
routes:
switch(config)# show ip mroute
IP Multicast Routing Table for VRF "default"
(*, 225.1.1.207/32), uptime: 00:13:33, ip pim
Incoming interface: Vlan147, RPF nbr: 147.147.147.2, uptime: 00:13:33
Outgoing interface list: (count: 0)
Extranet receiver in vrf blue:
(*, 225.1.1.207/32) OIF count: 1
(40.1.1.2/32, 225.1.1.207/32), uptime: 00:00:06, mrib ip pim
Incoming interface: Vlan147, RPF nbr: 147.147.147.2, uptime: 00:00:06
Outgoing interface list: (count: 0)
Extranet receiver in vrf blue:
(40.1.1.2/32, 225.1.1.207/32) OIF count: 1
switch(config)#
For detailed information about the fields in the output, see the Cisco Nexus 7000 Series Command
Reference.
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
176
Configuring Multicast Extranet

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents