Cisco Nexus 7000 Series Configuration Manual page 178

Configuring MSDP Peer Parameters
Before you begin
Ensure that you have installed the Enterprise Services license and enabled PIM and MSDP.
Procedure
Step 1
Step 2
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
164
Command or Action
config t
Example:
switch# config t
switch(config)#
Option Description
Sets a description
ip msdp
string for the peer.
description
By default, the peer
peer-ip-address
has no description.
Example:
switch(config)# ip
msdp description
192.168.1.10 peer in
Engineering network
Shuts down the
ip msdp shutdown
peer. By default, the
peer-ip-address
peer is enabled
Example:
when it is defined.
switch(config)# ip
msdp shutdown
192.168.1.10
Enables an MD5
ip msdp password
password for the
peer-ip-address
peer. By default, no
password
MD5 password is
Example:
enabled.
switch(config)# ip
msdp password
192.168.1.10
my_md5_password
Enables a route-map
ip msdp
policy for incoming
sa-policy
SA messages. By
peer-ip-address
default, all SA
in
policy-name
messages are
Example:
received.
switch(config)# ip
msdp sa-policy
192.168.1.10
my_incoming_sa_policy
in
Purpose
Enters global configuration mode.
The following commands configure the MSDP
peer parameters.
Configuring MSDP