Cisco Nexus 7000 Series Configuration Manual page 41

Configuring IGMP
Command or Action
Option
ip igmp static-oif
route-map
source] | policy-name}
switch(config-if)# ip igmp static-oif
230.0.0.0
ip igmp startup-query-interval
seconds
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Purpose
Description
Caution
Statically binds a
source
{group [
multicast group to the
outgoing interface, which
is handled by the device
hardware. If you specify
only the group address,
the (*, G) state is created.
If you specify the source
address, the (S, G) state is
created. You can specify
a route-map policy name
that lists the group
prefixes, group ranges,
and source prefixes to use
with the match ip
multicast command.
Note
Sets the query interval
used when the software
Configuring IGMP Interface Parameters
The device
CPU must be
able to handle
the traffic
generated by
using this
command.
Because of
CPU load
constraints,
using this
command,
especially in
any form of
scale, is not
recommended.
Consider using
the ip igmp
static-oif
command
instead.
A source tree
is built for the
(S, G) state
only if you
enable
IGMPv3.
27