Cisco Nexus 7000 Series Configuration Manual page 60

Configuring MLD Interface Parameters
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
46
Command or Action
Option
ipv6 mld static-oif
source route-map
[ source] |
policy-name}
Example
switch(config-if)# ipv6 mld static-oif
FFFE::1
ipv6 mld startup-query-interval
seconds
Example
switch(config-if)# ipv6 mld
startup-query-interval 25
ipv6 mld startup-query-count
count
Example
switch(config-if)# ipv6 mld
startup-query-count 3
ipv6 mld robustness-variable
value
Purpose
Description
Caution The device
CPU must
handle the
traffic
generated by
using this
command.
Statically binds a
group
{
multicast group to the
outgoing interface, which
is handled by the device
hardware. If you specify
only the group address,
the (*, G) state is created.
If you specify the source
address, the (S, G) state is
created. You can specify
a route-map policy name
that lists the group
prefixes, group ranges,
and source prefixes to use
with the match ip
multicast command.
A source tree
Note
is built for the
(S, G) state
only if you
enable
MLDv2.
Sets the query interval
used when the software
starts up. Values can
range from 1 to 18,000
seconds. The default is 31
seconds.
Sets the query count used
when the software starts
up. Values can range from
1 to 10. The default is 2.
Sets the robustness
variable. You can use a
Configuring MLD