Configuring Sparse Mode With Auto-Rp(Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring Sparse Mode with Auto-RP(CLI)

Command or Action
Step 5
end
Example:
Device(config)# end
Step 6
show running-config
Example:
Device# show running-config
Step 7 copy running-config startup-config
Example:
Device# copy running-config
startup-config
Related Topics
Rendezvous Points, on page 129
Configuring a Rendezvous Point, on page 143
Example: Configuring Candidate RPs, on page 184
Configuring Sparse Mode with Auto-RP(CLI)
Before You Begin
• An interface configured in sparse-dense mode is treated in either sparse mode or dense mode of operation,
• All access lists that are needed when Auto-RP is configured should be configured prior to beginning the
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
162
depending on the mode in which the multicast group operates. You must decide how to configure your
interfaces.
configuration task.
Purpose
The access list is always terminated by an implicit deny statement for
everything.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Configuring PIM
OL-32598-01