Cisco Nexus 7000 Series Configuration Manual page 40

Configuring IGMP Interface Parameters
Step 2
Step 3
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
26
Command or Action
interface interface
Example:
switch(config)# interface ethernet 2/1
switch(config-if)#
Option
ip igmp version
value
switch(config-if)# ip igmp version 3
ip igmp join-group
source route-map
[ source] |
policy-name}
switch(config-if)# ip igmp join-group
230.0.0.0
Purpose
Enters interface mode on the interface type and
number, such as ethernet slot/port.
These commands are used to configure the
Description
IGMP interface parameters.
Sets the IGMP version to
the value specified.
Values can be 2 or 3. The
default is 2.
The no form of the
command sets the version
to 2.
Statically binds a
group
{
multicast group to the
outgoing interface, which
is handled by the device
hardware. If you specify
only the group address,
the (*, G) state is created.
If you specify the source
address, the (S, G) state is
created. You can specify
a route-map policy name
that lists the group
prefixes, group ranges,
and source prefixes to use
with the match ip
multicast command.
Note
Configuring IGMP
A source tree
is built for the
(S, G) state
only if you
enable
IGMPv3.