Cisco Nexus 7000 Series Configuration Manual page 42

Configuring IGMP Interface Parameters
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
28
Command or Action
Option
switch(config-if)# ip igmp
startup-query-interval 25
ip igmp startup-query-count
count
switch(config-if)# ip igmp
startup-query-count 3
ip igmp robustness-variable
value
switch(config-if)# ip igmp
robustness-variable 3
ip igmp querier-timeout
switch(config-if)# ip igmp
querier-timeout 300
ip igmp query-timeout
switch(config-if)# ip igmp query-timeout
300
ip igmp query-max-response-time
seconds
Example
switch(config-if)# ip igmp
query-max-response-time 15
ip igmp query-interval
Purpose
Description
starts up. Values can
range from 1 to 18,000
seconds. The default is 31
seconds.
Sets the query count used
when the software starts
up. Values can range from
1 to 10. The default is 2.
Sets the robustness
variable. You can use a
larger value for a lossy
network. Values can range
from 1 to 7. The default is
2.
Sets the querier timeout
seconds
that the software uses
when deciding to take
over as the querier.
Values can range from 1
to 65,535 seconds. The
default is 255 seconds.
Sets the query timeout
seconds
that the software uses
when deciding to take
over as the querier.
Values can range from 1
to 65,535 seconds. The
default is 255 seconds.
Note This command
has the same
functionality as
the ip igmp
querier-timeout
command.
Sets the response time
advertised in IGMP
queries. Values can range
from 1 to 25 seconds. The
default is 10 seconds.
Sets the frequency at
interval
which the software sends
Configuring IGMP