Bowflex Max Trainer M7 Service Manual page 85

10. Using a #2 Phillips screwdriver, remove the indicated screw from the
Rear Shroud.
11. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it releases. Then move the screwdriver to the bottom and gently pry
until the Rear Shroud comes off.
Rear Shroud
12. Remove the indicated Caps from the machine.
Cap Cap
13. Using a #2 Phillips screwdriver, remove the indicated (by oval) screw
and only loosen the lowest indicated screw (arrow) from the Left Fan
Cover.
14. The Left Fan Cover Assembly has a tab that needs to be pushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
15. Using a #2 Phillips screwdriver, remove the 2 indicated screws from
the Right Crank Cover.
16. Remove the Right Crank Cover from the machine.
Pivot Arm
17. Place a rag or protective material below the Right Connector Arm to
protect the Shrouds from potential scratches from the Connector Arms.
Crank Cover
Connector Arm
18. Using a 6mm hex wrench, remove the hardware that connects the
Right Connector Arm and the Pivot Arm.
Note: The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shroud.
85