Bowflex Max Trainer M7 Service Manual page 48

18. The Brake Magnets should be aligned with the Brake Disc and cen-
tered around the Brake Disc.
19. If the Brake Assembly only needs to be slightly adjusted, loosen the
front screw that secures the Brake Assembly using a 10mm hex wrench.
Rotate the Brake Assembly until the Magnets are aligned and of equal
distance from the Brake Disc.
If the Brake Assembly must be fully shifted, loosen the 2 screws that
secure the assembly and shift it until centered and aligned with the Brake
Disc. Fully tighten the hardware.
Brake Assembly
Rotate the Brake Disc to be sure it does not make contact with the mag-
nets. If further adjustment is needed, repeat step 20.
20. Installation is the reverse procedure.
21. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
48
Brake Disc
Brake Assembly
Magnets
=