Bowflex Max Trainer M7 Service Manual page 127

*
20. Using a #2 Phillips screwdriver, remove the screws from the
Right and Left Shrouds. ( 3 screws on the Right Shroud, 9 on the
Left Shroud) Remove the upper screws labeled ' * ' last.
21. Carefully remove the Shrouds from the machine.
If replacing the Right Fan Cover:
A. Using a 15mm open face wrench, remove the Securing Ring
from the outside of the Right Fan Cover.
B. Remove the Power Inlet from the inside of the Right Fan
Cover.
22. Installation is the reverse procedure.
Note: When replacing the Crank Arms, be sure the Right and Left
Crank Arms are oriented inline and opposite each other.
The Crank Nuts should be tightened to a torque value of 29-32.5
ft lbs (or 350-390 in lbs).
23. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully as-
sembled and inspected for correct performance in
accordance with the Owner's Manual.
Right Side
Securing Ring
127
*
Left Side
Power Inlet