Bowflex Max Trainer M7 Service Manual page 46

6. Using a #2 Phillips screwdriver, remove the 3 indicated screws
from the Brake Disc.
7. Carefully remove the Brake Disc from the machine.
8. Place a piece of tape on the Brake Cable immediately above the
Brake Arm. During re-assembly, the tape will be a guide for the place-
ment of the new Brake Arm on the Brake Cable.
9. While applying upward pressure to the Brake Arm, remove the
hardware that secures the Brake Cable to the Brake Arm with a
1.5mm hex wrench. Once loose, gradually lower the Brake Arm.
Note: Be aware that the Spring will pull the Brake Arm once
released. An object can be placed under the Brake Arm to supply
resistance during the release of the Brake Cable Hardware.
10. Remove the Brake Spring from the Brake Arm.
46
Brake Disc
Brake Assembly
Magnets
Brake Assembly
Brake Cable
Brake Arm
Brake Cable
Hardware
Brake Spring
Brake
Disc