Bowflex Max Trainer M7 Service Manual page 122

17. The Brake Magnets should be aligned with the Brake Disc
and centered around the Brake Disc. If they are not aligned and
centered, then the Magnets are adding drag.
18. If the Brake Assembly only needs to be slightly adjusted,
loosen the front screw that secures the Brake Assembly using
a 10mm hex wrench. Rotate the Brake Assembly until the Mag-
nets are aligned and of equal distance from the Brake Disc.
If the Brake Assembly must be fully shifted, loosen the 2 screws
that secure the assembly and shift it until centered and aligned
with the Brake Disc. Fully tighten the hardware.
19. Installation is the reverse procedure.
20. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct performance
in accordance with the Owner's Manual.
122
Brake Disc
Brake Assembly
Magnets
=