Needle Will Not Move / Machine Goes To Sleep While In Use - Bowflex Max Trainer M7 Service Manual

Needle will Not Move or Machine Goes to Sleep While in Use
BEGIN HERE
Replace the Speed
Sensor Assembly
Issue resolved.
Remove the hardware from the
right lower round cover. To
remove the right lower round
cover, the power plug inlet wire
must be gently released from
the inside of the cover.
Once the power plug inlet wire
is released, remove the cover
from the machine.
Is the sensor
YES YES
damaged?
NO
Is the sensor wire
unplugged from the
YES
main wire harness?
NO
Rotate the fan so that one of the
magnets meets the tip of the
sensor. Adjust the sensor so
that there is an 1/8 inch (3mm)
gap between the sensor and the
magnet (about the thickness of
2 pennies held together).
Plug the power back in and test
the machine.
The speed sensor is located at
the front of the frame pointing at
the fan. Look closely at the tip of
the sensor and check for any
damage.
Does the issue
persist?
YES
Contact Customer
Care for Advanced
Troubleshooting
13
Issue resolved.
NO