Bowflex Max Trainer M7 Service Manual page 134

13. Using a #2 Phillips screwdriver, remove the indicated (by oval) screw
and only loosen the lowest indicated screw (arrow) from the Left Fan
Cover.
14. The Left Fan Cover Assembly has a tab that needs to be pushed
upward to clear the loosened screw. While pushing up on the tab, remove
the Left Fan Cover Assembly.
15. Remove the Left Fan Cover Assembly from the machine. Be sure to
note how the fan screens are set into the Left Fan Cover to assist with the
replacement procedure.
16. Using a #2 Phillips screwdriver, remove the 2 indicated (by ovals)
screws from the Crank Cover. Repeat on the other side of the machine.
17. Remove the Left Crank Cover from the machine.
Pivot Arm
18. Place a rag or protective material below the Connector Arm to protect
the Shrouds from potential scratches from the Connector Arms.
19. Using a 6mm hex wrench, remove the hardware (indicated by arrows)
that connects the Connector Arm and the Pivot Arm.
Connector Arm
Note: The Connector Arm will pivot downward if not lowered slowly onto
the rag protecting the Shrouds
Crank Cover
134