Haier Smart Power Series Service Manual page 79

Smart Power
Accessories supplied with the indoor unit:
No.
1
2 Wired controller
3 3/8" Brass nut (liquid side)
4 5/8" Brass nut (gas side)
5 Coupler heat insulation(gas side)
6 Coupler heat insulation(liquid side)
7
8
9 Cable tie(Large)
10 Cable tie(small)
Note
All wiring of this installation must comply with NATIONAL, STATE AND LOCAL REGULATIONS. These instructions
do not cover all variations for every kind of installation circumstance. Should further information be desired or
should particular problems occur, the matter should be referred to your local distributor.
WARNING
Be sure to read these instructions carefully before beginning installation. Failure to follow these instructions could
cause serious injury or death, equipment malfunction and/or property damage.
Preparation of indoor unit
Before or during the installation of the unit, assemble necessary optional panel etc. depending on the specific type.
Select places for installation satisfying following conditions and at the same time obtain the consent on the part of
your client user.
a.Places where chilled or heated air circulates freely. When the installation height exceeds 3m warmed air stays
close to the ceiling. In such cases, suggest your client users to install air circulators.
b.Places where perfect drainage can be prepared and sufficient drainage.
c. Places free from air disturbances to the suction port and blowout hole of the indoor unit, places where the fire
alarm may not malfunction or short circuit.
d.Places with the environmental dew point temperature is lower than 28 C and the relative humidity is less than
80 %. (When installing at a place under a high humidity environment, pay sufficient attention to the prevention of
dewing such as thermal insulation of the unit. )
e.Installation dimension is the following.
Name of parts
Signal line
Drain pipe
Instructions
Quantity Note
Connection between the
1 wired remote control and
electric control board
For Air conditioner
1
operation
1 For tightening the
1
Connecting pipe
For indoor side pipe
1
joint(gas side)
For indoor side pipe
1
joint(liquid side)
Drainage fittings group
1
(For ADHM series only)
1 Air conditioner operation
For fixing the heat
7 insulation
(For ADHH series only)
For fixing the remote
controller cable and
4
connecting cable
(For ADHH series only)
77
Shape